Product Detail
CPN60 Nitrogen Generator 
CPN60 Nitrogen Generator
Contents

Inflating generator is easy to setup following

•Plug unit power cord into power source.Connect a compressed air supply line to the inlet located on the Pre-Filter.

•Turn the uniton by depressing the Power Switch. The Unitwill immediately begin to produce nitrogen. The nitrogen pressure gauge located on the Unit above the Pre-Filter assembly will.

•indicate the nitrogen pressure in the system.

•The Unit is ready for use when the nitrogen pressure gauge indicates a pressure of 72 psi or greater. Dons Easy to operate following.

Converting Tire to NITROGEN

•Set the final target pressure.

•Connect the tire fill hose to the tire valve stem.

•Press and hold the "FILL/PURGE" for 2 seconds, Release the "FILL/PURGE" when HN2PH appears on the LCD display screen.

•When the cycle is completed, the unitwill "beep" and the target pressure will flash on the LCD screen.

•Immediately disconnect the tire fill hose.

Topping-Off Tire with NITROGEN

•Set the final target pressure.

•Connect the tire fill hose to the tire valve stem.

•Press the "FILL/PURGE" momentarily (for less than 1 second). The unit will inflate or deflate the tire(s) to the target pressure.

•When the top-off cycle is completed, the unitwill "beep" and the target pressure will flash on the LCD screen.

•Immediately disconnect the tire fill hose.

Feature

Easy to setup.

Auto-Coverting air to Nitrogen in tire -Auto-Topping Off nitrogen.

Unit display : psi,kPa,bar

Product parameters

35-2.png


About Us                                Products                                 Contrast                                News                                     Join Us
Wheel Balancer
Tire Inflator